关键词: 连续重整, 板壳式换热器, 压力降, 热端入口温度

Abstract: In this paper ,the principle of heat transfer and the main control factors of pressure drop of lamella heat exchanger were studied combining with the analysis of the physical properties of the feed, then the method of reducing the pressure drop on the feed side was given, which supported by test verification. The results showed that the pressure drop on the feed side of the heat exchanger can be reduced by reducing the amount of circulating hydrogen and reforming feed, but both of them were under control; the overall pressure drop on the feed side of the lamella heat exchanger can be reduced by decreasing the inlet temperature of the lamella heat exchanger, that is, the inlet temperature of the final reactor; the pressure drop on the feed side can be reduced by 0.31~0.53 kPa for one degree Celsius decrease in the inlet temperature of the heat exchanger ,predicting the temperature of the fourth reactor will drop by 30 ℃, the overall pressure drop at the feed side will drop by 9~15 kPa.

Key words: continuous catalytic reforming unit, lamella heat exchanger, pressure drop, inlet temperature of hot side