Petroleum Refinery Engineering ›› 2024, Vol. 54 ›› Issue (6): 13-17.
• PROCESSING • Previous Articles Next Articles
Hu Longwang
Received:
Online:
Published:
胡龙旺
作者简介:
Abstract:
This article introduces the industrial practice of dynamic and static two-stage combined filtration technology in the slurry filtration unit of the catalytic cracking unit of SINOPEC Jinling Petrochemical Co., Ltd. The primary system of the technology adopts dynamic filtration technology, while the secondary system adopts static filtration technology. Under the condition of controlling the purification oil slurry yield of the primary filtration system to not exceed 85%, assisted with primary self-cleaning and secondary backwashing membrane tube regeneration technology, the system can be conducted to long-term operation. During the experiment of processing purchased oil slurry, there was a significant increase in the differential pressure of the primary filter. In order to improve the stable operation level of the device, it is necessary to strengthen the analysis of the properties of the purchased oil slurry. Industrial calibration data showed that under the condition of a feed rate of 25 t/h and a 45% blending ratio of purchased oil slurry, the total purified oil slurry yield of the unit was 95.29%, the ash content of the purified oil slurry was less than 100 μg/g, and the ash removal rate was as high as 99.8%. Long term operation data showed that under high load conditions, the quality and yield of purified oil slurry products in the unit can meet the requirements. The differential pressure control of the two-stage filter was stable, and there was no obvious wear or thinning of the pipeline, which can meet the requirements of long-term industrial operation.
Key words: catalytic cracking, oil slurry, purification, dynamic filtration, static filtration filter, pressure difference, pipeline wear, ceramic membrane
摘要:
动态与静态二级组合过滤技术在某公司催化裂化装置油浆过滤单元进行了工业实践。该组合技术一级过滤系统采用动态过滤技术,二级过滤系统采用静态过滤技术。控制一级过滤系统净化油浆收率不大于85%,并辅以一级自清洗及二级反冲洗膜管再生技术,有利于系统的长周期运行。加工外购油浆试验期间,一级过滤器压差出现明显上升,为提高装置平稳运行水平,需加强对外购油浆性质的分析。工业标定数据表明,在进料量25 t/h、外购油浆掺炼比例为45%的条件下,该装置总净化油浆收率95.29%,净化油浆灰分小于100μg/g,灰分脱除率高达99.8%。长周期运行数据表明,在高负荷条件下连续运行,装置净化油浆产品质量与收率均可满足指标要求,两级过滤器压差平稳,管道未见明显磨损减薄,可以满足长周期工业运行的要求。
关键词: 催化裂化, 油浆, 净化, 动态过滤, 静态过滤, 过滤器压差, 管道磨损, 陶瓷膜
Hu Longwang. Industrial practice of dynamic and static combined filtration technology for oil slurry in catalytic cracking unit[J]. Petroleum Refinery Engineering, 2024, 54(6): 13-17.
胡龙旺 . 催化裂化油浆动态与静态组合过滤技术工业实践[J]. 炼油技术与工程, 2024, 54(6): 13-17.
0 / / Recommend
Add to citation manager EndNote|Ris|BibTeX
URL: https://journal01.magtechjournal.com/lyjsygc/EN/
https://journal01.magtechjournal.com/lyjsygc/EN/Y2024/V54/I6/13
[1] 刘晓丽.催化油浆净化技术的研究进展[J].山东化工,2019,48(5):71-73.
[2] 邱洪卫,任万忠,曾涛.催化裂化油浆液固体系分离技术探讨[J].山东化工,2015,44(23):48-51.
[3] 唐课文,刘磊,古映莹,等.催化裂化油浆的过滤分离研究及利用[J].现代化工,2007(S1):340-343.
[4] 谢明强,魏晓伟.陶瓷分离膜的制备、过滤机理和应用研究[J].山东陶瓷,2006(6):29-34.
[5] 刘喜峰,李冬怀,张利锋,等.重油催化油浆过滤技术概述[J].四川化工,2007(4):12-15.
[6] 陈强,蔡连波,盛维武,等.浆态床动态错流过滤技术的研究[J].炼油技术与工程,2021,51(12):15-18.
[7] 陈强,蔡连波,盛维武,等.催化油浆固液分离新技术[C]//中国石油学会.2017年中国石油炼制科技大会论文集.北京:中国石化出版社,2017:300-304.
[8] 史载锋,范益群,徐南平,等.颗粒体系错流过滤过程的数学模拟[J].高校化学工程学报,2000(6):535-540.
[9] 陈庆岭,王宁.催化裂化油浆膜过滤技术工业应用研究[J].石油炼制与化工,2020,51(9):45-49.